Porcelain Tile / September 14, 2018 / Brousseau
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
Attach the appropriate diamond core bit to the electric drill and ensure that there is a constant supply of cold water that is being directly aimed at the diamond core i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water directed at the drill bit in order to keep the diamond core cool and to help remove any debris that may have built up whilst drilling the tile. It is not advisable to try and cool the diamond drill bit by using a hand held aspirator or drilling through a wet sponge.
The Armeg PTC Carbide drill bit range comprises of excellent porcelain tile drill bits that are capable of cutting 15-25 holes in grade 5 porcelain or 50+ in lesser grades of porcelain. These carbide drill bits boast non-slip start-up thanks to diamond-ground tip geometry. The Armeg PTC Soft Tile drill bit range is ideal for drilling softer tiles such as ceramics and travertine. They feature point-ground tips to help reduce slippage and wander. Armeg Tile Drilling Accessories for use with Armeg PTC drill bits include: water feed pump kit water feed adapters water feed clamp & drive/piloting guides to ensure non-slip start-up with small diameter diamond cores.