Porcelain Tile / September 7, 2018 / Brousseau
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
The Kaska glazed porcelain offers a Tiger Cotto and Noce series. These tiles are comparatively priced and offer a full colour body porcelain tile. These tiles are made in Turkey and have standard edges and a PEI 4 rating. These tiles are ideal for floors or walls in any home with any amount of traffic. The glaze on the tiles helps to protect and lengthen the life of the tiles so they can be used in the kitchen near the doors or even on the walls to beautify your home.
The Armeg PTC Diamond drill bit range boasts diamond core drill bits that are capable of cutting hundreds of holes in all grades of porcelain. They feature thin wall continuous diamond crowns for and fast and efficient cutting and an extended life. These diamond cores are not to be confused with short-life diamond grit alternatives. Not only do these diamond drill bits cut porcelain they also cut materials such as marble granite travertine slate quarry tiles ceramic tiles natural stone and limestone.