Porcelain Tile / August 31, 2018 / Brousseau
Drilling holes into porcelain tile should take seconds not minutes. If it is taking you minutes it is likely that you are not applying enough pressure or that you are using an incorrect setting on the power tool. Best Tools for the Job. In order to drill perfect holes in porcelain tile it is extremely important to use premium quality drill bits. Armeg have been producing innovative high quality drilling solutions for over 30 years and Armegs PTC (Porcelain Tile Cutter) range is at the forefront of tile drilling technology.
These tiles offer more water resistance and frost resistance than ceramic tiles. Glazed porcelain tiles offer a surface that is resistant to wear and tear and a harder surface that is great for high traffic areas such as the kitchen or tea room. Full porcelain floor tiles have a colour and pattern that follows through to the base of the tile so the patterns are never worn away like ceramic tiles. Glazed porcelain tiles are coated with liquid glass and then baked so that the protection is impervious to wear and tear as well as stains.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.