Porcelain Tile / September 14, 2018 / Brousseau
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
To get more acquainted with the product porcelain is defined in the Meriam-Webster Dictionary as a fine grained translucent ceramic ware. There are different kinds of ceramic materials but porcelain comes from the more common type of material called whiteware. Porcelain was first discovered in China and it is believed to have been brought to Europe by the great merchant and explorer Marco Polo. The term porcelain was derived from the translucent shell porcellana because of its similarity to the cowrie shell.