Porcelain Tile / September 14, 2018 / Brousseau
Glazed porcelain tiles are ideal for the perfect flooring in your home. There are many differences between porcelain tiles and ceramic tiles for use on your floors or walls. Ceramic tiles are made from red or white clay and are fired then finished with a glaze that helps the pattern and colours to be sustained. These are normally easy to cut due to softer materials and have a PEI 0-3 rating. Porcelain tiles are made by dust pressed methods from porcelain clay that creates a fine grain and smooth face.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
The Armeg PTC Diamond drill bit range boasts diamond core drill bits that are capable of cutting hundreds of holes in all grades of porcelain. They feature thin wall continuous diamond crowns for and fast and efficient cutting and an extended life. These diamond cores are not to be confused with short-life diamond grit alternatives. Not only do these diamond drill bits cut porcelain they also cut materials such as marble granite travertine slate quarry tiles ceramic tiles natural stone and limestone.