Porcelain Tile / September 9, 2018 / Brousseau.
Drilling holes into porcelain tile should take seconds not minutes. If it is taking you minutes it is likely that you are not applying enough pressure or that you are using an incorrect setting on the power tool. Best Tools for the Job. In order to drill perfect holes in porcelain tile it is extremely important to use premium quality drill bits. Armeg have been producing innovative high quality drilling solutions for over 30 years and Armegs PTC (Porcelain Tile Cutter) range is at the forefront of tile drilling technology.
With porcelain being one of the most popular choices of tile material available and with the trend for porcelain tile set to continue tilers have had to adapt their working methods and tools to be able to cater for the demands of their clients. Until recently a large number of tile fixers have shied away from the installation and drilling of porcelain tiles due its perceived difficulty. However drilling holes in porcelain tile is not difficult! Using the correct methods and the best tools for the job it is possible to achieve perfect cuts in a matter of seconds.
When it comes to deciding which tile to use in your home most people waver between choosing porcelain tile or a ceramic white tile. Certainly both have great qualities bringing beauty and charm into the space you are living in. Good quality tile adds an elegant tastefulness to a room as well as providing flooring that can stand up to more use than wood or carpet. This is why its so important to make sure youre choosing the right kind of tile. Everyone loves the clean bright look of white tile so its little wonder that people wonder if they should use ceramic or porcelain tile. A lot of DIY tile installers ask the difference between the two and the answer is surprising. Despite a superficial similarity differences abound between the two types of tile.
These methods will not keep the drill bits cool enough and will drastically shorten the life of the drill bit. Ensure that the drill is in normal mode and set the drill to between 1000 and 1500 rpm. If you have marked the tile with a marker it is best to drill into the tile using a method called leaning in. Leaning in ensures that the drill will not slip and wander off center as you begin to drill into the tile.