Porcelain Tile / September 14, 2018 / Brousseau
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.
The polished porcelain on the other hand goes through a more refined process and comes out looking almost like a granite finish or has a glossy effect without the glaze. In choosing the perfect ceramic porcelain tiles for your finishing you must know the colour combination or contrast in the areas where you will install the tiles and the kind of exposure the tiles may be subjected to. You may discuss these with your architect or interior designer or you may refer to our website and get in touch with us so we can assist you the best way we can.
These methods will not keep the drill bits cool enough and will drastically shorten the life of the drill bit. Ensure that the drill is in normal mode and set the drill to between 1000 and 1500 rpm. If you have marked the tile with a marker it is best to drill into the tile using a method called leaning in. Leaning in ensures that the drill will not slip and wander off center as you begin to drill into the tile.