Porcelain Tile / September 14, 2018 / Brousseau
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.
The polished porcelain on the other hand goes through a more refined process and comes out looking almost like a granite finish or has a glossy effect without the glaze. In choosing the perfect ceramic porcelain tiles for your finishing you must know the colour combination or contrast in the areas where you will install the tiles and the kind of exposure the tiles may be subjected to. You may discuss these with your architect or interior designer or you may refer to our website and get in touch with us so we can assist you the best way we can.
Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the carbide drill bit with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.