Porcelain Tile / September 14, 2018 / Brousseau
Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the carbide drill bit with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
The polished porcelain on the other hand goes through a more refined process and comes out looking almost like a granite finish or has a glossy effect without the glaze. In choosing the perfect ceramic porcelain tiles for your finishing you must know the colour combination or contrast in the areas where you will install the tiles and the kind of exposure the tiles may be subjected to. You may discuss these with your architect or interior designer or you may refer to our website and get in touch with us so we can assist you the best way we can.
Identifying the Size of Hole to be Drilled. The first step is to correctly identify the size of hole to be drilled. This is very important as the diameter of the hole to be cut dictates the method that you will use to drill into the tile. The majority of holes that are 10mm and under in diameter will be drilled with the tile already fixed to the wall. Conversely the majority of holes over 10mm in diameter will be drilled into the tile before the tile has been fixed. When drilling holes that are 13mm or larger in diameter make sure that the tile to be drilled is placed in a tray that will collect the waste water that is produced.